Mantis ComposT-Twin Benutzerhandbuch Seite 50

Step 16
GB
1st panel has 2 door
slots
19
There are two different types of ribs on the panels: one rib is straight, the other is clip-shaped.
Place panels on a flat ground surface with the ribs facing up, in the following order:
The two slots of the drum 1st panel (key No.19) should be next to the door opening (key No.18).
The clip-shaped rib of the 2nd panel (key No.18), door opening, should face the 1st panel.
The 4 latch holes of the drum 3rd panel (key No.20) should be next to the flat rib of the 2nd panel.
The clip-shaped rib of the drum 4th panel (key No.21) should be next to the drum 3rd panel.
Place the drum's 1st panel in a position where the
straight rib is facing the door panel's clip-shaped rib.
Align outside edges to align holes. Slide the clip-shaped
rib of the door panel over the straight rib of the drum's
1st panel, matching up the holes. If necessary, tap into
place with a hammer or rubber mallet.
Step 19
Attach 3rd and 4th panels the same way to complete
the first chamber assembly. Assemble the sheet metal
panels for the second chamber using the same
procedure.
50
2nd panel
door opening
Clip-shaped rib
18
Step 17
Position mesh screen (key No. 23) onto the vent hole
of the end cap. Affix it using the #10 shoulder screw
(key No. 30 and the #10 locking nut (key No. 31).
Repeat this step with the second end cap.
3rd panel has
4 latch holes
20
L
!
SAFETY WARNING
USE OF A HAMMER ON DRUM PANELS MAY
DAMAGE PAINT. COVER PANEL EDGE WITH
A CLOTH BEFORE USING HAMMER.
Step 18
4th panel has
one clip-shaped
rib
21
L
!
Fasten panels using
screw (key No. 27), flat
washers (key No. 28 and
Keps nut (key No.29).
Tighten screws using
3/8" (10 mm) wrench
and a flat head
screwdriver.
Step 20