Adjusting The Spring Balancer - EFA SK18 S Originalbetriebsanleitung

4.4 Adjusting the spring balancer

The fine adjustment of the spring balancer
takes place via the PLUS/MINUS screw on its
housing (see fig. 10).
Fig. 8 Spring balancer
 Turn the screw in MINUS direction until the
saw is hanging freely in equilibrium (with the
spring balancer) at working height.
If the cutter cannot be pulled out, the spring bal-
ancer is jammed and a readjustment is neces-
sary:
 Turn the screw in PLUS direction until the
saw can be pulled out and start the fine ad-
justment again (see above).
Schmid & Wezel Seite / Page
21 / 28
Stand / Version
08 / 2018