Klarstein Lausanne Bedienungsanleitung Seite 8

The appliance can be operated either by the switches located on the top right hand side of the fire
or by the supplied remote control.
Manual Operation
1. This is done by operating the switches located at the top right hand side of the fire .The standby
rocker switch must first be switched on, the fire will beep to indicate that it is powered up.
2. Press the O/I button once to turn on the appliance and fire effect. A red indicator light will show
to indicate that the fire is ON. Press the O/I button for 3 seconds this will operate the dimmer
mode, hold the button down until the desired brightness is obtained.
3. Press the POWER button once for the low heat setting 1000W; press twice for the high heat set-
ting 2000W; press three to switch off the heat setting.
4. Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors available.
Remote Operation
1. The standby rocker switch located at the top right hand side of the fire must first be switched
on; the fire will beep to indicate that it is powered up. It takes a little time for the receiver to
respond to the transmitter. Do not press the buttons more than once within two seconds for the
fire to operate normally.
2. Press the ON/OFF button once to turn on the appliance and fire effect.
3. Press the 1000W/2000W button once for the low heat setting 1000W; press twice for the high
heat setting 2000W; press three to switch off the heat setting.
4. Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors available.
5. Press the DIMMER button to operate the dimmer mode, repeat pressing will raise and lower the
brightness.
INSTRUCTIONS FOR USE
8