Klarstein Lausanne Bedienungsanleitung Seite 7

This appliance is designed to be permanently fixed to a wall at a minimum height of 300mm.The wall
bracket must be fitted horizontally and the cable routed to the bottom right of the heater.
A distance of 600mm from bottom of heater to floor is recommended for optimum viewing of fuel bed;
see Fig.1 for recommend fixing dimensions.
For optimum viewing, mark the top four screws fixing positions on wall in accordance with the recom-
mend fixing dimensions- see Fig.2.
NOTE: ensure that the bracket is level by using a Spirit level whilst marking out the hole positions.
Drill holes with a No. six drill bit.
Fix the wall bracket using that the plug and screws provided.
Attach the lower fixing bracket the base of the fire using the two small black screws supplied; ensure the
bracket is fitted so that it is level with the back.
Carefully lift the heater up ensuring that the top rear ledge of heater engages with the wall bracket (see
Fig.2 in circle) and is sitting centrally. This process should be carried out by two people to avoid injury or
damage to property or the appliance.
Gently bring the heater down against the wall.
Mark the lower fixing bracket two fixing hole positions on the wall-see Fig.3, remove the heater.
Drill the wall and insert the wall plugs.
Refit the heater to the wall and fasten the bottom fixing bracket to the wall using the screws provided to
permanently fix the heater in place.
Unpack the pebbles from the bag and place them along the light unit in the desired position.
Place the front surround over the front of the fire aligning the slots in the brackets at each side of the front
panel with the lugs on the sides of the fire-see Fig.4.
Again two people will be required for this operation.
7