Cleaning And Storage - Cleanmaxx SMY-02664 Gebrauchsanleitung

5. Press the On / Off switch again. The device switches to operating mode and begins
to clean.
During operating mode, the pump switches on at regular intervals to moisten the
cleaning cloth. This is normal and does not indicate a defect.
7. Press the On / Off switch again in order to switch off the device. The control lamp
goes out.
8. After use, empty the water tank and clean the device (see the "Cleaning and Storage"
chapter).
Tips
• To guarantee the longest possible operating time, we recommend charging up the
battery of the device fully before each use.
• We recommend staying in preparation mode for approx. 30 seconds so that the
cleaning cloth is suffi ciently moistened.
• Switch off the device after you fi nish cleaning each surface to increase the operating
time on each battery charge. The device can then be placed directly into operating
mode by pressing the On / Off switch twice as it is not necessary for the cleaning
cloth to be moistened again.
• If the cleaning cloth should become too dry during use despite being regularly mois-
tened during the operating mode, set the device to preparation mode and maintain
this until the cleaning cloth has reached the desired level of moistness.

Cleaning and Storage

PLEASE NOTE!
■ Empty the water tank after each use of the device to prevent deposits in the water
tank and any damage to the device resulting from this!
■ Do not use any sharp or abrasive cleaning agents or cleaning pads. These can dam-
age the surfaces.
1. Detach the cleaning cloth from the cleaning attachment (4) and wash it in accordance
with the specifi cations on the washing label.
2. Empty and rinse out the water tank (2):
– Detach the water tank (see the "Filling the Water Tank" chapter).
– Pull out the fi lter plug and pour away all the remaining water.
– Rinse out the water tank thoroughly under running water.
21
6. Guide the cleaning attachment over the surface to be
cleaned from top to bottom. The surface is cleaned at the
same time and the dirty water is sucked up. Make sure that
the scraper lip is always against the surface to be cleaned
and slide the device over the surface with light pressure. It
is not necessary to apply strong pressure.
Please Note: If the control lamp fl ashes alternately green
and red, the water in the water tank needs to be changed
and the battery needs to be charged.
EN