Cleaning, Care And Storage - Cleanmaxx JC-232 Gebrauchsanleitung

EN
7. Slide the cleaning foot slowly back and forth over the fl oor. The fl oor is cleaned as
you do this.
8. If during use no steam or only a very small amount of steam is produced, press the
handle rod down again several times. If steam still does not emerge from the cleaning
foot, check whether there is suffi cient water in the water reservoir (9) and top it up if
necessary (see "Filling the Water Reservoir").
9. When you fi nish cleaning the fl oor, move the On / Off switch to position 0 and pull the
mains plug out of the plug socket.
10. Allow the device to cool down completely.

Cleaning, Care and Storage

PLEASE NOTE!
■ Before commencing the cleaning, note the safety instructions in the "Safety
Instructions" chapter!
■ CAUTION – Danger of burns! The fl oor cloth and the cleaning foot may be very hot
during and shortly after use. Before removing them, wait a few minutes until the fl oor
cloth and the cleaning foot have cooled down completely.
■ Do not use any solvents, aggressive cleaning agents or cleaning pads for cleaning.
They could damage the device.
• Completely empty the water reservoir after each use:
– open the water reservoir cap (8),
– hold the main unit (6) over a sink or similar outlet and tip out the rest of the water,
– ideally do not close the water reservoir (9) again immediately so that the moisture
can escape,
– close the water reservoir again using the water reservoir cap before storing it away.
• Wipe down the device with a soft, slightly damp cloth if necessary and then dry it with
a soft cloth.
• The fl oor cloth (12) can be washed in the washing machine. Follow the instructions on
the washing label. Do not use any fabric softener or bleach!
• Store the device in a frost-free, dry, clean, cool place that is not accessible to children
and animals.
Care
To ensure that the steam cleaner can clean with full force, the water reservoir (9) should
be descaled at regular intervals (after approx. 25 – 50 uses).
1. Pour a mixture of one part vinegar and two parts water into the water reservoir.
2. Position the device in such a way that the steam that is emitted does not hit any
delicate fl oors or other objects.
3. Insert the mains plug into a properly installed plug socket that is easily accessible.
4. Move the On / Off switch (7) to position I to switch on the device.
5. Allow the vinegar/water mixture to run through once completely until the water
reservoir is empty.
6. Move the On / Off switch to position 0 to switch off the device and pull the mains plug
out of the plug socket.
7. Rinse the water reservoir with fresh water to remove vinegar residues and odours.
01784_DE-EN-FR-NL_A5_V2.indb 18 01784_DE-EN-FR-NL_A5_V2.indb 18
18
02.02.2018 11:44:52 02.02.2018 11:44:52