Filling The Water Tank; Attaching / Detaching The Cleaning Cloth; Use - Cleanmaxx SMY-02664 Gebrauchsanleitung

EN
• The device has a dirty water sensor. After the water tank is fi lled or the water is
changed, this measures the particle density in the liquid. The dirty water sensor uses
this output value to determine when the water needs to be changed.
Please Note: The dirty water sensor is reset once the battery has been charged or
once the control lamp has displayed a water change and the device has then been
switched off.

Filling the Water Tank

4. Pull the fi lter plug out of the water tank.
5. Fill the water tank with water and a little window cleaning agent if necessary. Please
Note: The water tank holds approx. 90 ml.
6. Close the water tank with the fi lter plug. Make sure that the fi lter plug fi ts correctly
when you do this.
7. Attach the water tank to the motor unit (8). To do this, fi rst insert the end with the fi lter
plug into the device and press the other end against the handle until you feel and hear
the water tank engage.

Attaching / Detaching the Cleaning Cloth

• Attaching: Place the cleaning cloth on the hook-and-loop surface (5) on the bottom
of the cleaning attachment (4) and press it on fi rmly.
• Detaching: To detach the cleaning cloth, pull it off the cleaning attachment.

Use

PLEASE NOTE!
■ Never clean screens (televisions, computer monitors etc.) with the device. Electrical
devices of this type are not resistant to moisture.
■ Do not suck up large amounts of water at once. Only use on vertical surfaces.
■ Do not detach the water tank during use.
■ Do not use the device when it is connected to the mains power.
1. Attach the cleaning cloth to the cleaning attachment (4) (see the "Attaching / Detach-
ing the Cleaning Cloth" chapter).
2. Fill the water tank (2) (see the "Filling the Water Tank" chapter).
3. Press the On / Off switch (10). The control lamp (9) lights up constantly green. The
device is in preparation mode and the pump switches on.
4. Wait until the cleaning cloth is suffi ciently damp.
20
1. Hold the device by the handle (11) with one hand.
2. Reach around the water tank (2) with your other hand and
press your thumb against the handle until the water tank
is released (see picture). Some force may be required to
do this.
3. Take off the water tank.