Use; Cleaning And Storage - Cleanmaxx 05991 Gebrauchsanleitung

EN
Attaching / Removing Attachments
• Plug the attachment you want onto the main unit (6) so that the markings on the at-
tachment and main unit point towards each other. The attachment must be heard to
engage in place.
• To remove the attachment, simply pull it off the main unit (6).

Use

NOTE!
■ Keep animals, hair, jewellery, wide clothing away from rotating parts of the device. If
something does become caught in the device, switch it off immediately.
■ The device should only be used if it has been completely and correctly assembled!
■ Always switch off the device fi rst before attaching or removing attachments!
■ Do not use the device when it is connected to the mains adapter.
Switch the device off after each surface has been cleaned as this will considera-
bly increase the operating time on each battery charge.
1. Plug on the attachment you want (see the "Assembly" chapter).
2. Press the On / Off switch on the handle (9) to switch on the device.
3. Guide the attachment over the surface which is to be cleaned or polished.
4. To switch off the device, press the On / Off switch on the handle (9) again.
5. Clean the used attachment after use (see the "Cleaning and Storage" chapter).

Cleaning and Storage

NOTE!
■ Make sure that the device is switched off before cleaning it!
■ Never immerse the device, the mains adapter or the mains cable in water or other
liquids.
■ During cleaning make sure that no liquid gets into the main unit, the handle or the
extension rod. Only the attachments may be cleaned with water.
■ Only reassemble the device once all of the parts are completely dry.
■ Do not use any sharp or abrasive cleaning agents to clean the housing. They could
damage the surfaces.
The attachments may lose some of their colour over time. This is normal and does
not have any adverse effect on function. However, if one of the attachments is
damaged or worn, it must be replaced.
• Clean the housing of the main unit (6), the handle (9) and the extension rod (2) with
a damp, soft cloth if necessary. Then dry them with a soft cloth.
• Regularly remove hair and fl uff from the attachments and if necessary clean them
with warm water and a mild cleaning agent. Then allow them to dry completely!
05991_DE-EN-FR-NL_A5_V2.indb 18 05991_DE-EN-FR-NL_A5_V2.indb 18
18
23.01.2018 17:29:06 23.01.2018 17:29:06