Troubleshooting - h.koenig KB20 Bedienungsanleitung

indicator of "ADD WATER" will keep lighting. At this time,
you just need to press POWER button again, the machine
can enter normal state.
4. To ensure the cleanness of ice, please change water for
water reservoir at least once one day. If do not use for a
long time, please drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water,
fully water or interruption of power supply, it will delay for
3mins to start up after restarted.
6. Always use fresh water before starting ice production
either at initial installation or after a long shut-off period.
TROUBLESHOOTING ：
Please note, if a power failure occurs due to disconnection of the power cord, or the power button
1.
has been pushed off during an ice making cycle, small ice chips may formed and lodge in the
automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting
the power cord and gently pushing the shovel to the rear of the cabinet and removing the ice
chips, then restarting.
Please check if the water reservoir is flat when the ice shovel can not remove the ice to ice basket.
2.
If not, please push the ice shovel gently by finger, then press POWER button to restart.
PROBLEM
The compressor works
abnormally with a
Buzzing
Noise
Water shortage indicator
light is on
Indicator lights on
display are not on
The Ice made is too
large
and with pieces sticking
together.
All indicators twinkle
simultaneously
POSSIBLE CAUSE
The voltage is lower than
recommended
1.There is no water
2.The pump is full of air
Blown fuse/ No power
1.water temperature is too low
2.Ice of previous cycles left in the
water tray
Water tray is blocked by ice cube
SUGGESTED SOLUTIONS
Stop the Ice maker and do not restart until the
voltage is normal.
1.Add to some water until it reaches MAX
position
2.Press POWER button to restart
Replace fuse / Turn power on
1.Select small size
2.Take out the ice under the standby state
Unplug the power to take out the ice which
blocking the tray, then plug the power and
press the POWER button, the machine will
restart 3mins later.
8