Troubleshooting - h.koenig KUBE Bedienungsanleitung

How to cancel the timer
When the unit has been set with the timer or during the timer setting process, press the
TIMER button, then the delay time digit will disappear, mean the timer set has been cancelled.
CLOCK DISPLAY & THE CORRECT TIME
Clock
1
Time
2 5
3 6
4 7
CLEANING REMINDING
When the symbol
unit, always press the TIMER button for more than 5 seconds, this symbol will disappear from
the LCD display window. And the cleaning timer will reset to Zero and reaccount again.

TROUBLESHOOTING

PROBLEM
" flashs.
Symbol"
" display in
Symbol"
LCD display window.
Ice cubes stick together.
Ice making cycle is normal
but no ice is made.
This unit is supplied with CLOCK dipalying function.
If the displayed time is not correct, you can adjust it to the
correct digit through the CLOCK and SELECT button.
First press the CLOCK button once, the digit meaning hour will
start to flash first, then you can press SELECT button to change
it, each press will increase 1 hour. Press the CLOCK button
again, the digit meaning minute then will start to flash, and also
press the SELECT to change it. Then press the CLOCK the third
time to confirm it, and now it display the new correct clock. And
during adjusting process, after 5 seconds flashing, the digit will
automaticall change to always displaing, also means the new
clock has been set.
flashs, means the unit need to be cleaned. And if you have cleaned the
POSSIBLE CAUSE
Lack of Water.
There is too much ice.
The ice cycle is too long.
Water temperature in inner
tank is too low.
Ambient temperature
water temperature in inner
tank is too high.
Refrigerant liquid leakage.
Pipe in the cooling system
is blocked.
SOLUTION
Stop the ice maker, fill water, and
press "ON/OFF" button again to
restart the unit.
Remove ice from ice basket.
Stop the ice maker, and restart it
when the ice blocks melt. Select
the small size ice cube selection.
Change the water in the inner
Tank. Temperature of water is
better set between 45℉-90℉ .
Please run the ice maker below
or
90℉ and pour colder water into
tank.
Verify by a qualified technician.
Verify by a qualified technician.