Eufab 16472 Bedienungsanleitung Seite 5

6.1 OVERVIEW
Figure 1: Front view
Figure 2: Side view
6.2 CONNECTING A USB DEVICE
The cables must not hinder the driver when moving
Find out how to connect this in the manual for your USB device. If there is no information, proceed as follows:
• Switch off your USB device.
• Connect your USB device using a USB connector (position 6, Figure 1 for a load current of 2.4 A or position 7, Figure1 for a load current of 1.0A)
on the charging adaptor.
• If your vehicle has an on-board power socket connected to the ignition, first switch on the ignition.
• Insert the plug of the charging adaptor into the on-board power socket. The indicator lamps will light up (position 1 and 3 Figure 1).
• Switch on the USB device to be used. The control lamps (position 4 and/or 5, Figure 1, depending on connection) now light up.
• To be able to read the display, the USB charging adaptor is fitted with a hinge. This allows the display to be tilted upwards or downwards
(Figure 3).
6.3 WARNING FOR LOW BATTERY VOLTAGE
If the battery voltage falls below 11.8 V, the red warning "LOW" lights up on the display of the charging adaptor (position 2, Figure 1) and a
warning signal sounds. If this occurs, immediately remove your USB device from the charging adaptor, as described in point 6.4.
6.4 REMOVING A USB DEVICE
• Switch off the USB device.
• Pull the charging adaptor plug out of the on-board power socket.
• Separate your USB device from the charging adaptor.
Always pull the charging adaptor out of the on-board power socket when the vehicle is switched off otherwise the
battery may be discharged.
7. MAINTENANCE AND CARE
7.1 MAINTENANCE
The USB charging adaptor is maintenance-free when used for the intended purpose.
7.2 CARE
Clean the housing of the charging adaptor with a soft, dry cloth. Do not use any abrasive or solvent-based cleaning agents. Never allow liquids
to ingress into the housing.
8. NOTES REGARDING ENVIRONMENTAL PROTECTION
Do not dispose of electrical devices with household waste. Electrical and electronic scrap must be collected separately and
disposed of in an environmentally responsible manner for recycling. Please contact your community or city administration
regarding disposal options for electrical and electronic scrap.
9. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
1 Control lamp for battery symbol
2 Low-battery indicator
3 Battery voltage indicator
4 Control lamp for 1.0 A output
5 Control lamp for 2.4 A output
6 2.4 A output
7 1.0 A output
8 Hinge
9 Earth contact (-)
10 Positive contact (+)
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Figure 3: Adjustment options
info@eal-vertrieb.com
www.eal-vertrieb.com
5