Siemens SCALANCE W786-2HPW Betriebsanleitung Seite 76

Procedure
Figure 3-6
Follow the steps below to screw a SCALANCE W786 to a wall:
1. Lead the cables into the housing of the SCALANCE W786 (position A in the figure
above). Note the information in the section "Connecting up cables".
2. Secure the SCALANCE W786 to the wall with three screws (position B in the figure
above). The screws are not supplied with the device. The type and length of the screws
depend on the type of wall.
Option: Threaded holes on rear of housing
When a wall is extremely thin, it is often not possible to use wall plugs for the screws. To
allow wall mounting even in this situation, there are four M4 threaded holes on the rear of the
SCALANCE W786. The drilling template is a square with sides 100 mm long. The device can
therefore be mounted on a wall with bolts through the wall.
SCALANCE W786-2HPW
Operating Instructions (Compact), 06/2007, A5E01186485
3.3 Mounting without an adapter (wall mounting only)
SCALANCE W786 wall mounting
B
A
Mounting
17