Siemens SCALANCE W786-2HPW Betriebsanleitung Seite 71

Mounting
3.1 Removing / fitting the housing cover
Fitting the housing cover
12
Siemens Drives & PLCs
Figure 3-1 Removing the cover
A Sealing cap
B Cover screw
C Housing cover
Follow the steps below to remove the housing cover:
1. Remove the sealing caps from the housing cover (position A in the figure above)
2. Loosen the screws in the cover (position B in the figure above).
Note
These screws remain in the cover after they have been loosened (prevents them being
lost). Never attempt to remove these screws from the housing cover using force,
otherwise the housing cover will be damaged!
3. Remove the housing cover with the captive screws (position C in the figure above).
Fitting the housing cover is carried out in the reverse order. The tightening torque for the
cover screws is 1.8 Nm.
- 3
8 6
W 7
C E
A N
A L
S C
F
R 3
R 2
R 1
P 1
P o E
L 1
s
C
B
A
Operating Instructions (Compact), 06/2007, A5E01186485
SCALANCE W786-2HPW