Setting Up A Bluetooth Connection With Mobile Devices - Omnitronic WAMS-JOBT Bedienungsanleitung

1
Disengage the button MP3/AUX to assign the signal of the audio player to channel 1
2
Insert a USB device into the USB port and/or a memory card into the card slot.
3
After loading a data carrier, it is selected as the playback medium and the playback will start
automatically. The display indicates "► ". During the playback, the display indicates the elapsed and total
time of the current title in minutes and seconds. Additionally, the file name will be scrolling across the
display.
4
Use the buttons [+] und [‒] on the remote control to adjust the basic volume level of the audio player.
Then mix the player's signal to the master signal with the LEVEL control.
5
To interrupt the playback, press the button [► ]. The display indicates " ". To stop the playback, press
the button [ ]. The display indicates " ". After pressing the button [► ], playback will start from the
beginning of the title.
6
By short actuation of the buttons [
long actuation on the remote control, fast forward and reverse is activated. By long actuation one the
unit, the audio player's internal volume can be adjusted.
7
For direct selection of a title with the numerical keys [0-9] on the remote control, enter its number.
8
With the button [
• indication „A": continuous repeat of all titles of the data carrier (basic setting)
• indication „1": continuous repeat of the selected title
• indication „F": continuous repeat of the selected folder
• indication „N": normal play
• indication „R": the titles are played in random order
• indication „I": intro play, i.e. the first ten seconds of each title of the data carrier are successively played
9
Short repeated actuation of the button [EQ] selects an equalizer setting: "POP", "JAZZ", "CLAS", "COV" or
"BAS". When set to "NOR", the frequency response is not affected.
10
To remove a USB device, disconnect it from the USB port. To eject a memory card, slightly press it into
the slot until it comes out and can be removed. Prior to removing a device, always terminate the
playback with the buttons [►II] or [ ]. Otherwise damage or loss of data may occur.

Setting up a Bluetooth Connection with Mobile Devices

The built-in audio player features a Bluetooth receiver allowing you to stream music wirelessly from your
mobile devices such as smartphones, tablets and notebooks.
1
Press the MODE button (repeatedly) on the audio player or the remote control until the display indicates
BT NOT LINK "
" .
2
Activate the Bluetooth function on your mobile device and keep it at hand to pair it to the receiver. The
Bluetooth receiver is indicated by "
approx. 10 meters.
3
Once the Bluetooth receiver is connected to your mobile device, the audio player's display indicates "
CONNECTED
" as well as information about your mobile device and is ready to play music. Just play
music on your mobile device as you normally would and the sound will come out of the PA system.
4
To interrupt or continue the playback, press the button [► ].
5
With the buttons [
6
To switch over to playback of a USB device or a memory card press the button MODE (repeatedly).
] and [
], you can activate random play and repeat functions.
Bluetooth
] and [ ] on the remote control you can skip titles in forward or backward direction.
] you can skip titles in forward or backward direction. By
" on the display of your mobile device and has a range of
41
BT