Operating The Appliance; Place Glass Container / Yogurt Cups In Appliance; Connect Appliance To The Mains; Select A Programme - Rommelsbacher Jona JG 80 Bedienungsanleitung

Operating the appliance

• Please take care that the appliance is not moved during the maturing process to prevent
interruption of the fermentation process.
• Before use, clean glass container and yogurt cups thoroughly and rinse them with hot water.

Place glass container / yogurt cups in appliance

• Put the filled glass container (with lid) respectively the filled yoghurt cups (with lids) into the inner pot
of the appliance.
• Attach the cover. Pay attention to the correct position of the cover.

Connect appliance to the mains

Select a programme

Change time setting

or
22
The lid of the glass container is equipped with a venting valve.
• Before attaching the lid, first open the venting valve by pressing the venting
button. The lid can be easily attached like this. After attaching it, close the valve.
• To remove the lid, first open the venting valve by pressing the venting button.
The lid can be easily removed like this.
• First, plug in the power cord to the plug-in connection on the back side of the
appliance. Check for a tight and correct fit of the power cord. When the power
cord is too loose, this may result in damage at cord and plug!
• Now, connect the mains plug to a socket.
• All pilot lamps in the display light up shortly. Afterwards the display shows
2 hyphens and additionally there is a 'beep'. The appliance is ready for use.
NOTE: If there is no further activation of a button within the next 30 seconds,
the appliance will switch back to standby mode and both hyphens expire. By
tapping the button for programme selection again, the appliance returns to
operating mode.
• Touch the button for programme selection repeatedly, until the desired pro-
gramme is lit.
• A proposal for the maturing time is shown in the display. The time setting as
well as the pilot lamp of the respective programme are blinking (e. g.: pro-
gramme "Joghurt").
NOTE: If there is no further activation of a button within the next 10 seconds,
the appliance will switch back to operating mode (2 hyphens in the display).
• If necessary, the maturing time can be adjusted individually. For doing so,
touch the button "+" several times for increasing the maturing time respec-
tively the button "-" for reducing the maturing time.
NOTE: The time can be adjusted in hourly steps.