Safety In Use; Operating The Appliance - Rommelsbacher RT 350 Bedienungsanleitung

Safety in use

IMPORTANT:
• In general put the appliance into the water before use!
• Pull the mains plug after each use. Then wait ca. 15 seconds
before taking the unit out of the water.
• Do not put the hot appliance on fl ammable or sensitive surfaces.
Always let the appliance cool down before being put away!

Operating the appliance

IMPORTANT:
In general put the appliance into the water before use!
• Only use slim, temperature-resistant containers holding approximately the following volumes::
- 0,25 litres for travel immersion heater of model RT 350 (accessory glass at RTG 351: 0.2 l)
- 1,25 litres for immersion heater of model TS 1001 and TS 1502
- 5,00 litres for immersion heater of model TS 2003.
• Place the container on a heat resistant insulating pad (e.g. a ceramic tile) to avoid heat transfer
to the worktop.
• Before using the appliance for the fi rst time and as well after having decalcifi ed it, we
recommend to boil clear water with the immersion heater for fi ve times and not to use this
water. This is especially important for persons suffering from an allergy.
• The marks indicated on the immersion heater show the maximum and minimum water level.
The water level must not exceed or fall below these marks as otherwise the appliance will be
destroyed and there is no right to claim under warranty!
• The immersion coil heater is equipped with an overheating protection which, in order to protect
the user, switches off forever in case of dry use.
• Should the immersion heater show a dark or bluish colour, there is no right to claim under
guarantee! In this case the immersion heater was used without or with an insuffi cient quantity
of water.
10