Fcc Compliance Statement - Spx Rd8000 Bedienungsanleitung

This instrument, or family of instruments, will not be permanently damaged by reasonable
electrostatic discharge and has been tested in accordance with IEC 801-2. However,
in extreme cases temporary malfunction may occur. If this happens, switch off, wait and
switch on again. If the instrument still malfunctions, disconnect the batteries for five
seconds and then reinstall and switch the unit on.
Compliance
EU Compliance
This equipment complies with the following EU Directives:
• R&TTE Directive: 1999/5/EC
• Low Voltage Directive: 2006/95/EC
• EMC Directive: 2004/108/EC

FCC Compliance Statement

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
• The equipment may not cause harmful interference.
• The equipment must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class A digital device pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the manufacturer's instruction manual, may cause
harmful interference with radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case you will be
required to correct the interference at your own expense.
Modifications:
Any modifications made to this equipment not approved by Radiodetection may void the
authority granted to the user by the FCC to operate this equipment.
Industry Canada Compliance Statements
ICES-003 Class A Notice:
This Class A digital apparatus complies with Canadian ICES-003.
Avis NMB-003, Classe A: Cet appareil numérique de la classe A est conforme à la norme
NMB-003 du Canada.
26