SPX RD8000 Bedienungsanleitung Seite 21

iLOC
iLOC is a standard feature of all RD8000 locator models. iLOC lets you control the
transmitter remotely using your RD8000 locator. With iLOC you can adjust the output
frequency, power settings and use SideStep. iLOC commands are sent over a Bluetooth
module that can operate at distances of up to 300m/1000ft in direct line of sight.
To use iLOC, the transmitter and locator must be paired.
NOTE: Operating in built up areas and in areas with high electromagnetic
interference may reduce iLOC's performance.
Using iLOC
The locator and transmitter need to be switched ON and paired to use iLOC.
For optimum performance:
• Face the back end of the transmitter towards the locator as this is where the
Bluetooth module is fitted
• If possible, raise the transmitter off the ground by 30-60cm (1-2ft)
• Try to avoid obstructions in line of sight
NOTE: If any iLOC commands fail, move closer to the transmitter and repeat
the process.
Changing frequencies
Once the transmitter and the locator are paired, you can change the transmitter's output
frequency remotely using the locator:
1. On the locator, select the frequency you want by pressing the
frequency is displayed on screen.
2. iLOC commands are sent using the
transmitter.
3. The locator's LCD will display SEND momentarily and then OK if the transfer is
successful.
4. If the transfer is unsuccessful, the LCD will display an error code.
If the process fails, you may be out of range or there may be an error in the connection.
Move closer to the transmitter and retry the procedure. If the connection continues to fail,
return to the transmitter and reset the connection.
Adjusting power
iLOC lets you adjust the transmitter's power output remotely; you can also put the
transmitter into standby mode and then wake it remotely.
key, press it to send the new frequency to the
21
key until the