SPX RD8000 Bedienungsanleitung Seite 22

1. Transmitter power options are located in the TXOUT menu on the locator.
Press and hold the
2. Press the key to enter the TXOUT menu.
3. Scroll up or down through the power output options; these are:
• STDBY: Transmitter standby mode, the connection is still active but the output
is disabled.
• LOW: Low power output.
• MED: Medium power output.
• HIGH: High power output.
• BOOST: Temporarily boosts transmitter power output to its maximum level.
4. Once you have selected the mode you want, press the
5. Press and hold the
6. Press the key once to send the settings to the transmitter.
NOTE: When changing the transmitter frequency using iLOC, the chosen transmitter
power setting will be retained.
Sleep/wake the transmitter
To help you prolong battery life you can put the transmitter in standby mode (sleep), and
reactivate it again, using the locator.
To put the transmitter into standby mode, set the TXOUT menu on the locator to STDBY
using the "Changing transmitter power output" procedure described above.
This will disable the transmitter output.
To re-activate the transmitter output, select any power mode from LOW to BOOST using
the same procedure.
If the process fails, you may be out of range or there may be an error in the connection.
Move closer to the transmitter and retry the procedure. If the connection continues to fail,
return to the transmitter and reset the connection.
SideStep
SideStep allows you to change the output frequency on the transmitter. SideStep
changes the selected frequency by several Hertz and automatically sets the locator's
locate frequency to match the transmitter's output frequency.
1. On the locator, select the frequency you want by pressing the
frequency is displayed on screen.
2. To step the frequency, press and hold the
3. Press the key to send the SideStep command to the transmitter.
4. If the command is sent successfully, an asterisk (*) will appear on the locator next to
the frequency and STEP will appear on the transmitter below the frequency.
5. Repeat this process to disable SideStep.
key to display the TXOUT menu.
key to select the new setting and exit the menu.
22
key to confirm.
key until STEP appears on the LCD.
key until the