General Information; Characteristics; Operating Limits; Choosing The Installation Site - Carrier AQUASNAP Installationsanweisung

Remote controller
General information and characteristics
IMPoRtaNt:
Read the entire instruction manual before starting the
installation.
• For trouble-free installation, which should be carried out by a
qualified installer, follow the installation chart sequence.
• Follow all current national safety code requirements.
• After installation thoroughly test the system operation and
explain all system functions to the owner.
• Leave this manual with the owner for consultation during future
periodic maintenance.
• Dispose of packaging material in accordance with local
requirements.
• The manufacturer denies any responsibility and warranty shall
be void if these installation instructions are not observed.
• Inspect equipment for damage due to improper transportation
or handling: file an immediate claim with the shipping company.
Do not install or use damaged units.
• In case of any malfunctioning turn the unit off, disconnect the
mains power supply and contact a qualified service engineer.
Models
Cooling only / heat pump

operating limits

The remote control is designed for indoor applications in
residential and/or commercial environments.
It is typically applied by fixing to the wall at a height accessible to
the operator, without any special limits usually required for analo-
gue equipment with internal temperature sensors.
The operating limits are:
Choosing the installation site and installation
Mounting
waRNING:
Before installing the remote controller, turn off all power
to the unit that will supply power to the remote controller.
Electrical shock can cause personal injury or death.
GB - 2
Products that the remote controller can interface with
30RA/30RH sizes 005 to 033.
wiring
• The remote controller must be connected to the 30RA/RH unit.
Power supply
Note that the remote controller requires no batteries.
The remote controller will not work without being connected to a
30RA/30RH unit.
Remote controller
NotE 1: configure the "REM" remote mode on the units
30Ra/RH 017-033 (see manual PRo-DIaLoG).
NotE 2: alarm and reset code display not available on units
30Ra/RH 017-033.
only the alarm status is available.
Maximum operating temperature
Minimum operating temperature
Maximum storage temperature
Minimum storage temperature
Maximum operating relative humidity
Maximum storage relative humidity
Nominal power supply voltage
• Turn OFF all power to unit.

+50°C
+0°C
+70°C
-10°C
80% r.h.
95% r.h.
24 V ac (+/- 10%)

 Mounting screws