Cleaning And Maintenance; In Case Of Failure - Mpm Mod-16 Bedienungsanleitung

1. Remove the outlet filter
housing and then remove the filter cartridge from its housing.
2. Remove the motor filter
move the dust bag
cartridge out of the housing.
3. Wash both filter cartridges under running and cool water. For thorough washing, add a small
amount of the detergent. Dry the filters thoroughly after washing.
4. Cartridges should be cleaned every month or more frequently (depending on the usage). If a
cartridge is too contaminated or damaged, replace it with a new one.
5. While mounting cartridges, pay special attention to the proper position of the cartridge in
the filter housing and the filter housing in the vacuum cleaner.
CAUTION: The filter cartridge being mounted must be completely dry. Mounting a wet filter may cause an
electric shock.

CLEANING AND MAINTENANCE

1. Periodically clean the vacuum cleaner housing and other external elements with a damp
cloth. This will allow maintaining good appearance of the appliance.
2. For this purpose, do not use sharp objects or any strong detergents (e.g. solvents), as this will
cause permanent damage to the vacuum cleaner housing.
3. For air filters and dust bag, follow the above instructions.

IN CASE OF FAILURE

Failure type:
front cover not thoroughly closed
vacuum cleaner housing overheating
low suction power
1! from the vacuum cleaner by pressing the lock button on the filter
To access the filter, raise the vacuum cleaner cover
2!
. Remove the motor filter
1@
Possible causes:
dust bag not attached or attached
improperly
a slight housing temperature increase is normal, but if the temperature increases
considerably, immediately turn off the vacuum cleaner and contact the service
strongly contaminated filters
full dust bag
blocked hose or extension pipe
by lifting it upwards and then pull its
2!
Instructions:
attach the dust bag properly
clean or replace the filters
replace the dust bag or empty the textile
bag
remove all items blocking the hose or pipe
and re-
t
13