Programming - IFM Electronic LK81-Serie Bedienungsanleitung

Programming

1
Mode/Enter Set
Mode/Enter Set
2
3
Mode/Enter Set
Change more parameters:
4
Start again with step 1.
*Decrease the value: Let the display of the parameter value move to the
maximum setting value. Then the cycle starts again at the minimum setting
value.
Timeout: If no button is pressed for 15 s during the setting procedure, the unit
returns to the Run mode with unchanged values (exception: cOP).
Locking / Unlocking: The unit can be electronically locked to prevent unwant-
ed adjustment of the set parameters: Press both pushbuttons for 10 s (until
is displayed). To unlock: Press both pushbuttons for 10 s (until
displayed).
Units are delivered from the factory in the unlocked state.
With the unit in the locked state
parameter values.
The sensor can be programmed before or after mounting. Exception: For the
adjustment of the measuring element OP the unit must be installed in the tank.
For programming carry out the following steps in the indicated order.
32
Press the Mode/Enter button
several times until the respective
parameter is displayed.
Press the Set button and keep
it pressed. The current parameter
value flashes for 5 s,
then the value is increased*
(incremental by pressing briefly or
scrolling by holding pressed).
Press the Mode/Enter button
briefly (= acknowledgement).
The parameter is displayed again,
the set parameter value
becomes effective.
Finish programming:
Wait for 15 s or press the
Mode/Enter button until the current
measured value is indicated again.
is indicated when you try to change
is