Conductivity Quick Setup - Mettler Toledo M300 Schnellkonfigurationsanleitung

8

Conductivity Quick Setup

For Display setup, analog outputs and setpoints see the section "General Setup".
Channel Selection
A
1.25
MΩ-cm
A
25.0
°C
Calibrate Sensor
Channel B Conductivity
Sensor Type Selection
1.25
µS/cm
25.0
°C
Sensor Type = Cond(2)
Cell Constant
1.25
µS/cm
25.0
°C
p M=0.1003 A=0.0000
s M=1.0000 A=0.0000
Measurement units
1.25
µS/cm
25.0
°C
a S/cm
Analog Output? Yes
14
(PATH: Menu/Quick Setup)
For multi-channel devices: Using the
user change the channel to be calibrated.
Select the type of sensor to be used with the M300 transmitter. Choices are "Cond(2)",
used for all 2-Electrode type sensors and "Cond (4)" for all 4-electrode sensors. Press
the [ENTER] key.
Enter the appropriate cell constant(s):from the sensor label or certificate (M) for 2-elec-
trode sensors, leaving (A) at 0.000; or (M) and (A) values for 4-electrode sensors.
Press the [ENTER] key.
Select the measurement (conductivity or temperature) and units for measurement.
If using analog output, select Yes. Refer back to section "General Setup" to continue
setup.
or key on the "Channel A" field lets the