General Assembly Requirements; Dts Cooling Unit Assembly (Side Attachment) - Pfannenberg DTS 3000 115V serie Technisches Handbuch

3.4.1 General assembly requirements

• Select an assembly location for the switch cabinet which will guarantee adequate ventilation of the cooling unit. A minimum
clearance of 200 mm between units and the nearest wall must be observed.
• Installed components in the switch cabinet must not impede air circulation.
• Protect the installation location from heavy contamination with covers.
CAUTION
The following general requirements must be followed for safe and reliable operation of the cooling units:
• Secure the switch cabinet against tipping.
• Ensure that provided hinges can support the additional weight of the cooling unit.

3.4.2 DTS cooling unit assembly (side attachment)

Make cut-outs for the DTS cooling unit
REQUIREMENTS:
• All general requirements have been fulfilled; see
• The unit is de-energized
REQUIRED TOOLS AND MATERIAL
• Saw
• Use a switch cabinet cutter, if applicable
• Protective covers
PROCEDURE
• Use a protective cover to protect the switch cabinet from chips.
• Provide the switch cabinet with cut-outs and holes. For the prescribed dimensions, refer to the figure exterior view of the
switch cabinet.
• Deburr the cut edges.
• Remove chips and assembly waste from the switch cabinet.
• Cut-outs and holes have been made.
Page 10
| OPERATING MANUAL DTS
General assembly requirements
Return To Table Of Contents