Care & Cleaning - Kenwood CM370 Serie Bedienungsanleitung

Use cold water. We recommend
G
using filtered water from a Kenwood
Water Filter as it reduces limescale.
Never use warm or fizzy water.
7 Replace the water tank back into the
coffee maker.
8 Ensure the filter holder is in position
in the coffee maker.
9 Fit either the permanent filter
supplied or a paper filter into the
filter holder. Add the coffee, use the
spoon provided (approximately 1
level spoon per cup or to taste).
10 Close the lid and adjust the aroma
control as required. Turn the control
to the left for stronger coffee and to
the right for weaker coffee.
11 CM370 series
G Put the carafe on the hotplate.
CM380 series
To achieve the best performance,
rinse the thermal carafe with hot
water immediately before switching
on the coffee maker.
G Screw the lid onto the thermal
carafe. For brewing, the lid should
be fully closed with the tab on the
lid in line with the carafe handle. Put
the carafe on the base.
12 Plug in and switch on, the light will
glow.
13 Don't remove the carafe until
brewing has finished.
CM370 series
G The hot plate will keep your coffee
hot, but the sooner you drink it, the
better it will taste.
G It is recommended to only keep the
machine switched on for a
maximum of 2 hours providing there
is coffee in the carafe. Do not leave
the machine switched on with an
empty carafe on the hotplate.
CM380 series
G To pour coffee after brewing has
finished, unscrew the lid 180° so
that the tab on the lid is in line with
the pouring spout. Once the desired
amount of coffee has been poured,
screw the lid back on to best retain
the coffee temperature.
As soon as all the coffee has
G
brewed, switch off and unplug the
machine.
If you haven't used the machine for
G
a while, run one lot of water through
it (without coffee) to clean it out. Fill
the water tank to the top cup mark
when you do this.
G Never put the carafe in the
microwave.
care & cleaning
G
Always switch off, unplug and allow
to cool before cleaning.
G
Never put the machine in water or let
the cord or plug get wet.
G
Don't wash parts in the dishwasher.
water filter
G
Change and discard the water filter
after 70 brewing operations or within
a calender month whichever is
sooner.
carafe, lid, permanent filter,
filter holder, water filter
holder
G
Wash, then dry.
body
G
Wipe with a damp cloth, then dry.
Don't use abrasives - they'll scratch
the plastic and metal surfaces.
descaling
You'll know when limescale has built
up because your coffee will take
longer to come through. When this
happens it's time to descale.
important
When descaling always remove the
water filter and water filter holder
first.
to descale
1 Buy a suitable descaler.
2 Descale the machine.
3 After descaling, run several lots of
water through the machine to clean
it out. Fill the tank to the top cup
mark when you do this.
4 Wash the parts.
3