Care & Cleaning - Kenwood kMix CM040-Serie Bedienungsanleitung

to make coffee
1 Lift up the water tank lid
2 Fill the tank with the desired amount
of water. The water level must be
between the 2 and 10 cup marks.
Do not fill above the MAX level.
Use cold water. We recommend
G
using filtered water as it reduces
limescale and prolongs the life of
your coffee maker. Never use warm
or fizzy water.
3 Lift the filter holder lid using the
handle at the front of the coffee
maker. Ensure the filter holder is
positioned correctly.
4 Fit either the permanent filter
supplied or a paper filter into the
filter holder. Add the coffee using
the spoon supplied. (Note: The
strength of your brewed coffee will
depend on the variety and strength
of coffee used not the amount. For
best brewing 1 level spoon (7g) of
coffee is recommended per cup).
5 Close the lid and put the carafe on
the hotplate. NOTE: The lid
must be fitted to the carafe
and closed in order to
operate the anti-drip valve.
6 Plug in and switch on.
7 Don't remove the carafe until
brewing has finished.
When the carafe is empty, switch off
G
and unplug the appliance.
The hot plate will keep your coffee
G
hot, but the sooner you drink it, the
better it will taste.
Your coffee maker will keep the
G
coffee warm and then automatically
switch off after 2 hours.
If you have not used the appliance
G
for a while, run one full tank of
water (without coffee) through to
clean it out.
care & cleaning
.
Always switch off, unplug and allow
G
to cool before cleaning.
Don't wash parts in the dishwasher.
G
carafe and lid, filter holder
and permanent filter holder
Wash, then dry.
G
body
Wipe with a damp cloth, then dry.
G
Don't use abrasives - they'll scratch
the plastic and metal surfaces.
mesh filter
The mesh filter
G
lifted out for cleaning if required.
Always ensure it is replaced before
filling the tank with water.
descaling
After approximately 90 brewing
cycles the descale warning button
that the coffee maker requires
descaling (see 'to descale').
to descale
1 Buy a suitable descaler.
2 Descale the machine.
3 After descaling, run at least two full
tanks of water (without coffee)
through the coffee maker to clean it
out.
4 Unplug and allow to cool. Then
wash the parts.
5 Plug in and switch on.
6 Reset the descale warning button by
pressing for 2-3 seconds until the
light goes out.
4
in the tank can be
will light up and flash to indicate