Teka GKS 30Gas Bedienungs-, Installations- Und Wartungsanweisung Seite 23

4) FIXING THE HOT PLATE
The hot plate has a special seal which prevents
liquid from infiltrating into the cabinet. Strictly
comply with the following instructions in order to
correctly apply this seal:
- take off all the movable parts of the hob.
- Cut the seal in 4 parts of the necessary lenght to
positionning it on the 4 edges of the crystal.
- Overturn the hot plate and correctly position seal
"E" (fig. 9) under the edge of the hot plate itself, so
that the outer side of the seal perfectly matches
the outer perimetral edge of the crystal. The ends
of the strips must fit together without overlapping.
- Evenly and securely fix the seal to the crystal,
pressing it in place with the fingers.
INSTALLATION
FIG. 9
- Remove the strip of protective paper from the seal.
Fit the hot plate into the hole in the cabinet and lock it
in place with the relative fixing screws "F" of the fixing
hooks "G" (see fig. 10).
- In order to avoid accidental touch with the
overheating bottom of the hob, during the working,
is necessary to put a wooden insert, fixed by
screws, at a minimum distance of 60 mm from the
top (see fig. 7).
23
FIG. 10