Install The Hardware - Axis P3365-VE Installationsanleitung

Install the Hardware

Prepare the Network Cable
If a cable other than the provided cable is used, you need to prepare a network cable with a gasket.
Gently force the cable through the gasket provided and attach a network connector. It may be
necessary to pierce a hole in the gasket with the resitorx screwdriver.
Note
• Do not force the network connector into the gasket.
• Do not pierce the gasket with a knife or other sharp object.
Prepare the Unit Casing (for routing cables along the wall)
If the cables are to be routed along the wall, prepare the unit casing as follows:
1. Detach the side lid that is attached to the unit casing by removing the screw.
2. Loosen the two screws on the cable shield and detach the bottom part.
3. Attach the bottom part of the cable shield to the unit casing with the screw.
1.
Cable shield (optional accessory) – top part
2.
Cable shield (optional accessory) – bottom part
3.
Unit casing
AXIS P3365–VE Fixed Dome Network Camera
1
2
16
3