Axis P3365-VE Installationsanleitung Seite 20

Adjust the Lens
1.
Lines to help with horizontal alignment
2.
Locking screw
Open the Live View page (see Access the Product, on page 21) in the web interface and make the
following adjustments to the camera:
1. Loosen the locking screw.
2. Turn the lens to the desired position. Make sure the lines on either side of the lens are
aligned horizontally. Ensure that the mark on the lens cover, between the horizontal
lines, is facing up.
3. Once satisfied, gently tighten the locking screw to secure the camera's position.
4. Open the Focus Adjustment page in the web interface under Setup > Basic Setup >
Focus & Zoom, and follow the on-screen instructions. Use the image window to adjust
the focus and zoom. See the online help files for more information.
Note
• Due to the dome's refraction, the image may appear slightly out of focus once the dome
has been placed. To correct this go to the Focus Adjustment page in the Web interface
under Setup > Basic Setup > Focus & Zoom, and adjust the focus again.
• Adjusting the focus and zoom manually can damage the lens.
Complete the Installation
1. Rotate the black shield inside the dome to match the camera's position.
2. If required, attach the weather shield to the camera before you attach the dome cover.
To do this remove the two screws in the dome cover. Transfer the washers from these
screws to the screws used on the weather shield, and attach the weather shield.
3. Make sure the rubber gasket sits securely on the dome cover, attach the dome cover to
the unit casing by tightening the 4 screws.
The installation is now complete.
AXIS P3365–VE Fixed Dome Network Camera
1
20
2