Pioneer NC-50DAB Bedienungsanleitung Seite 7

> Before Start > Part Names
Display
1. The input mode is displayed.
(USB Front / USB Rear / CD / Bluetooth / Network / Digital In 1 / Digital In 2 / Line /
Phono / Tuner DAB / Tuner FM)
2. The name of the file, artist, album, station, etc., is displayed.
3. Displays the play status.
4. Displays file format, sampling frequency, and quantization bit information.
5. The file play status is displayed. This may not be displayed depending on the input or file.
6. This is displayed when muting is on.
7. Lights in the following conditions.
: When the connection setting on the unit is "Wired" and the unit is connected to the network.
: When the connection setting on the unit is "Wired" and the unit is not connected to the network.
: When the connection setting on the unit is "Wi-Fi" and the unit is connected to the network.
: When the connection setting on the unit is "Wi-Fi" and the unit is not connected to the network.
8. If an album jacket is recorded for the file being played, it is displayed here.
9. Lights in the following conditions.
6
> Install > Initial Setup

USB Front
Song

Artist
Album

FLAC

44.1 /24
kHz bit

00:01:45 / 00:03:23
> Playback
 


: When all track repeat play is on
: When one track repeat play is on
1
: When shuffle play is on
0 When DIMMER is pressed to turn off the display, the unit may appear the same as if you
had unplugged the unit from the power outlet, but electricity is still being supplied to the
unit. To completely cut the unit off from the power supply, you need to unplug the power
plug (shutoff device) unit from the power outlet.
Advanced Setup | Firmware Update | Others
E
N