Defrosting, Cleaning And Maintenance; Automatic Defrost Function; Interior Light; Reversing The Door Hang - Hafele miniCool DS 200 Bedienungsanleitung

7. Defrosting, cleaning and
maintenance
Frost will gradually form on the cooling surfaces and it must
not be allowed to become too thick since it acts as an
insulator and interferes with the cooling.
The miniCool is fitted with a fully automatic, electronic
temperature regulator.
The frost will melt and the defrost water will run through the
drain tube from the drip channel into an evaporating vessel
located at the bottom rear of the refrigerator. (Fig 7) The
defrost water will evaporate automatically into the circulating
air and the vessel will not need emptying manually.
If we want to switch off the unit, disconnect the refrigerator
from the electricity supply and leave the cabinet door open.
After defrosting the cabinet interior should be wiped out
with a clean, damp cloth.

7.1. Automatic defrost function

The first defrosting phase commences 39 hours after the
initial operation and lasts for two hours.
After this, the device operates for 22 hours at a time,
followed by a defrosting period of 2 hours.

8. Interior light

Two light-emitting diodes (A) on an electronic PCB illuminate
the cooling compartment when the door is opened.
Two sensors (B) control whether the door is open or not and
the LEDs will work accordingly.
B
B

9. Reversing the door hang

Disconnect at the mains.
Lay the appliance on its side.
Loosen up 6 screws (1) of footframe and remove the
footframe.
Put the fridge on a desk to ease the work.
Open the door and snap out the fixing tab (2) of the
upper hinge pin by the help of screwdriver and push out
the pin. (fig. 10.)
Remove the door and the hinge washer.
Remove the bottom hinge pin (3) and the upper and
lower hinge plug (4) in the same way as in case of the
upper hinge pin.
Figure 7.
A
A
Figure 8.
(Fig. 9-10)
Snap in the lower hinge pin (3) to the desired side.
Put back the door and the hinge washer and snap in
the upper hinge pin (2).
Snap in the 2 hinge plugs (4) too.
Put back the footframe with its screws.
Figure 9.
Figure 10.
10. Replacing the decorative
door panel
If the refrigerator is furnished with handle, it is the handle
that should be first removed at the change of the door
panel.
Figure 11.
GB
(Fig. 11)
1
3
1
2
4
7