Defrosting, Cleaning And Maintenance; Interior Light; Reversing The Door Hang; Replacing The Decorative Door Panel - Hafele miniCool DS 300 H Bedienungsanleitung

GB
8. Defrosting, cleaning and
maintenance
Frost will gradually form on the cooling surfaces and it must
not be allowed to become too thick since it acts as an
insulator and interferes with the cooling.
We recommend to defrost the appliance in every 3 weeks,
or depending on the ice quantity on the cooling fins. While
defrosting the appliance should be switched off by
disconnecting the refrigerator from the electricity supply
and leave the cabinet door open.
The frost will melt and the defrost water will run through the
drain tube from the drip channel into an evaporating vessel
located at the bottom rear of the refrigerator. (Fig 5.)
After defrosting the cabinet interior should be wiped out
with a clean, damp cloth.

9. Interior light

Two light-emitting diodes (A) on an electronic PCB
illuminate the cooling compartment when the door is
opened.
Two sensors (B) control whether the door is open or not and
the LEDs will work accordingly.
B
B

10. Reversing the door hang

Disconnect at the mains.
Lay the appliance on its side.
Loosen up 7 screws (1) of footframe and remove the
footframe.
Put the fridge on a desk to ease the work.
Open the door and snap out the fixing tab (2) of the
upper hinge pin by the help of screwdriver and push out
the pin. (fig. 8.)
Remove the door and the hinge washer.
Remove the bottom hinge pin (3) and the upper and
lower hinge plug (4) in the same way as in case of the
upper hinge pin.
Snap in the lower hinge pin (3) to the desired side.
Put back the door and the hinge washer and snap in the
upper hinge pin (2).
Snap in the 2 hinge plugs (4) too.
6
Figure 5.
A
A
Figure 6.
(Fig. 7-8.)
Put back the footframe with its screws.
Figure 7.
Figure 8.
11. Replacing the decorative door
panel
(Fig. 9.)
If the refrigerator is furnished with handle, it is the handle
that should be first removed at the change of the door
panel.
1
Figure 9.
Remove the mounter screws (1) of the forehead
panel.(3)
Remove rosette (2) (in case of with lock version fridge).
Lift and remove the forehead panel.(3)
1
3
2
4