Cleaning; Positioning The Appliance; Installation Instruction; Built-In Version - Hafele miniCool DS 200 Bedienungsanleitung

1. Door lock (if available)
2. Door
3. Evaporator
4. Thermostat knob
5. Cooling unit room cover
IN CASE IF YOUR REFRIGERATOR IS EQUIPPED WITH LOCK, DOMETIC RT DO NOT ACCEPT
LIABILITY FOR LOSS OR DAMAGE OF KEYS. A COMPLETE LOCK CAN BE SUPPLIED.

3. Cleaning

Clean the refrigerator thoroughly at intervals, as
necessary. Remove the shelves; these, the cabinet
interior and the door should be washed with a warm
solution of sodium bi-carbonate. Finally wipe over with a
cloth rinsed in warm water only, and dry with a clean cloth.
Do not wash any plastic parts in water that is more than
hand warm, and do not expose them to dry heat. The
outside of the cabinet should be wiped down regularly with
a clean, damp cloth.
NEVER USE STRONG CHEMICALS OR ABRASIVE
CLEANING MATERIALS ON ANY PART OF THE CABINET.

4. Positioning the appliance

When first using this refrigerator please consider the
following points:
ENSURE REFRIGERATOR IS LEVEL
THE PIPEWORK AT THE BACK GETS HOT IN USE
THE REFRIGERATOR HAS NO 'MOTOR' AND IS
THEREFORE VIRTUALLY SILENT
ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING
During the refrigeration process, the appliance gives
off heat from the condenser (under the upper part of
DS 400
Figure 2.
6. Interior light
7. Shelves
8. Footframe
9. Sensor of Fuzzy Logic
10. Door racks
the rear cover) into the surrounding air. The more
ventilated the condenser is, the more effective the
refrigeration will be.
The other condition for satisfactory operation is that
the appliance stands on a flat surface. This is best
seen by placing a glass of water on top of the
appliance.
It is important that the appliance is not directly
exposed to radiated heat (sunlight, radiator, near an
oven, etc.).
Please do not place the refrigerator onto thick carpet!
4.1. Installation instructions
All four sizes of the miniCool family are available in built-
in and freestanding version.

4.1.1. Built-in version

This version is planned for building-in under purposes.
Built-in under model does not have foot frame, cooling
unit room cover, compared to the freestanding version.
(figure 1.).
The miniCool can be screwed to the furniture using the
fittings at the bottom. Drive in the screws (figure 3).
DS 600
GB
5