Fitting Up And Removing The Handle; Fitting Up The Handle; Putting Into Operation; Connecting To Electrical Mains - Hafele miniCool DS 200 Bedienungsanleitung

GB
Remove the mounter screws (1) of the forehead panel.(3)
Remove rosette (2) (in case of with lock version fridge).
Lift and remove the forehead panel.(3)
Slide the decorative panel (4) out of the door frame and
insert the new panel (thickness max. 2 mm).
Place back the forehead panel,rosette and screw in reverse
sequence.
11. Fitting up and removing the
handle
The handle which can be found among the accessories of
the appliance should be fitted and removed as follows:

11.1. Fitting up the handle

1

13. Putting into operation

Technical data:
Model DS 200
Type DS20-60
Gross volume 22,5 litre
Mains operation 220 - 240V (AC)
Input 65W
Energy consumption 0.74 kWh/24h
Climate class SN
Absorber Solution 147g H

13.1 Connecting to electrical mains

The appliance may only be operated from
nominal voltage mains as shown on the data
plate. The appliance mains plug may be connected to a
mains socket earthed in accordance with regulations.
Any electrical work required to install this appliance should
be carried out by a qualified electrician or competent
person.
The manufacturer declines any liability should these
safety measures not be observed.
8
(fig. 12., 13.)
Figure 12.
2
3
Figure 13.
DS 300
DS20-60
28,1 litre
220 - 240V (AC)
65W
0,76 kWh/24h
SN
O + 98 g NH 151g H O + 101 g NH
2 3 2

11.2. Removing the handle

3

12. Customer service

Before you call a service engineer, carry out the
following simple tests:
Is there a power failure? Check the fuses.
Is the plug firmly connected to the socket and is the
socket switched on? Check the socket by plugging in
another appliance, e.g. a table lamp.
Is the thermostat at the correct setting?
Has the door not been closed properly causing the
inside temperature to rise too quickly?
Is the refrigerator level?
Has the ventilation become obstructed?
If after checking all the above points, the refrigerator is
still not working satisfactorily, contact your nearest
service engineer. State the problem, model, product-
and serial-number.
(Details of the model, product- and serialnumber are to
be found on the data label in the top left of the inside
compartment.)
This refrigerator is equipped with overheating
protection. An authorised service technician can check
whether this has been triggered or not.
In the event of a fault developing, contact your nearest
Service Centre-see local telephone directory.
DS 400 DS 600
DS20-60 DS20-60
36,7 litre 52,6 litre
220 - 240V (AC) 220 - 240V (AC)
65W 85W
0.8 kWh/24h 0.88 kWh/24h
SN SN
151g H O + 101 g NH 157g H
3 2 3
Electrical Requirements
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate.
Only for UK:
The appliance is supplied with a 3 amp plug fitted. In the
event of having to change the fuse in the plug supplied,
a 3 amp ASTA approved (BS 1362) fuse must be used.
Should the plug need to be replaced for any reason, the
(fig. 14.)
1
2
Figure 14.
O + 105 g NH
2 3