Freestanding Version; Using The Appliance; Initial Operation; Temperature Regulation - Hafele miniCool DS 200 Bedienungsanleitung

GB

4.1.2. Freestanding version

This version is supposed to use freestanding. Cooling unit
room cover protects from the hot parts of the cooling unit.
Foot frame with grilles ensures sufficient ventilation.
IMPORTANT
Please follow the installation details below carefully
Guarantee is valid for products installed as described
only.
1. The refrigerator must be level both directions
2. There should be 20mm clearance to the wall
3. Ventilation must be provided as shown in
alternatives A, B, C or D (fig 4-5)
4. Only the entire cooling unit must project into the
duct as shown
5. Air passing through the duct must not be preheated
by any source of heat
6. Ventilation grills, if used, must have openings of at
least 200cm each
2
A
miniCool
Air in
6
Figure 3.
B
miniCool
Air in
Figure 4.
C
miniCool
Air in
Figure 5.
During installation, please ensure the mains plug is
accessible at all times.

5. Using the appliance

To start the refrigerator connect the plug to the socket
outlet and switch on the socket. The cooling fins should
show signs of cooling after about 1-2 hours depending on
ambiant temperature.

5.1. Initial operation

The device must be plugged into a properly earthed
socket.
The miniCool starts automatically with a self-test. The
LED illuminates after plugging-in several times and
after that continuous light can be seen if the door is
open.
The miniCool achieves its operating temperature after
several hours.

5.2. Temperature regulation

The usual setting required is in the region of the middle of
the thermostat knob (Fig. 6), but this can vary with
conditions of load and installation. If it is found necessary
to alter the setting,the knob can be turned to a higher
symbol to produce a colder temperature, or a lower
symbol to produce a warmer temperature. The effect of
any adjustment can be checked by means of a
thermometer after leaving the refrigerator operating for a
further period to settle down again.
Figure 6.
6. Useful suggestion
Do not overfill the appliance. It is advisable to leave
some space between the products in the cabinet to
ensure efficient and even cooling. If the shelves are
packed too tightly there may be unacceptable
temperature variations.
D
min. 60 mm
miniCool
Air in