Cleaning And Maintenance - Foster FlexDrawer FFC6-2 Bedienungsanleitung

GB

Cleaning and Maintenance

Important: Before cleaning, the unit should be put into standby and then the power supply should be
turned off at the mains. Please do not plug or unplug the unit with wet hands. Only when cleaning has
been completed and the unit is dry should the counter be turned back on at the mains.
Suitable P.P.E (Personnel Protective Equipment) should be worn at all times.
Regular Maintenance:
>
As and when required remove all product from the unit. Clean exterior and interior surfaces with mild
liquid detergent, following the directions on the pack at all times. Rinse surfaces with a damp cloth
containing clean water. Never use wire wool, scouring pads/powders or high alkaline cleaning agents i.e
bleaches, acids and chlorines as these may cause damage.
> Bin Removal
> Condenser Cleaning:
This should take place on a regular basis (4 to 6 weeks) or as and when required only by your supplier
(this is normally chargeable). Failure to maintain the condenser may invalidate the warranty of the
condensing unit and cause premature failure of the motor/compressor.
> All gaskets should be inspected on a regular basis and replaced if damaged. To clean, wipe with a warm
damp soapy cloth followed by a clean damp cloth. Finally thoroughly dry.
>
Drawers and their bins should be removed to clean. All should be cleaned with warm soapy water then
rinsed and dried before refitting to the counter.
> If fitted, the overshelf should be wiped down regularly with warm soapy water, rinsed and then dried as a
worktop would be.
> If fitted, the can opener should be maintained as any other kitchen utensil, be aware of possible sharp
parts when carrying out maintenance on this part.
4