Foster FlexDrawer FFC6-2 Bedienungsanleitung Seite 3

GB
Important Note to the Installer:
Please ensure that this document is passed to the user as it
contains important guidelines on operation, loading, cleaning and
general maintenance and should be kept for reference.
General Electrical Safety
Foster Refrigerator recommends that the equipment is electrically connected via a Residual Current Device; such
as a Residual Current Circuit Breaker (RCCB) type socket, or through a Residual Current Circuit Breaker with
Overload Protection (RCBO) supplied circuit.
Disposal Requirements
If not disposed of properly all refrigerators have components that can be harmful to the environment. All old
refrigerators must be disposed of by appropriately registered and licensed waste contractors, and in accordance
with national laws and regulations.
Start-Up and Test Sequence
After unpacking, clean and allow the counter to stand for 2 hours before turning on (cleaning directions
supplied within this manual). Ensure, where possible that the counter is situated away from both hot and
cold air sources, as this will affect its performance. Make sure effective ventilation around the unit is available
for optimum operation. Connect the unit to a suitable mains power outlet and turn the supply on. Do not plug or
unplug the unit with wet hands.
Counters are supplied ready for operation.
After connecting the unit to the mains the displays will briefly show a dash in the centre of the screen. This will
then show .
Activate the controller
Per drawer display:
3 Seconds
Cancel Test Sequence
Per drawer display:
Press & Release
1
Note: If not pressed the test will continue
and when complete the controller will show
' ' wait 1 minute, then resume normal
operation.
Note: If pressed and held for 5 seconds
then released a 'Test Sequence' will start
(see below instructions).