Recommendations On Installation - Sony IPELA SSM-L2xF1 series Bedienungsanleitung

Before operating the unit, please read this manual thoroughly and
retain it for future reference.
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified personnel
only.
ATTENTION
The electromagnetic fields at the specific frequencies may
influence the picture of this unit.
WARNING
Use the AC power adapter provided with this equipment as a
power supply source.
Manufacture: Sony
Type No.: NSR-AC1
Any other power sources may result in hazards such as a fire.
WARNING
When installing the unit, incorporate a readily accessible
disconnect device in the fixed wiring, or connect the power plug
to an easily accessible socket-outlet near the unit. If a fault should
occur during operation of the unit, operate the disconnect device
to switch the power supply off, or disconnect the power plug.
WARNING

Recommendations on Installation

Provide an ample amount of space around the display
• To prevent internal heat buildup inside the display, make sure
to ensure proper ventilation.
• Install the unit in an environment with an ambient temperature
of 5 °C to 40 °C (41 °F to 104 °F).
• When mounting the monitor, mount the monitor display in
landscape orientation only. Never install the unit vertically.
• When using a monitor stand, always use the SSMA-SU10
Monitor Stand (option). For details on installation, refer to the
Installation Manual for the monitor stand.
• If using a bracket, make sure that the monitor cannot fall.
Regarding the installation of hardware such as brackets,
screws, or bolts, we cannot specify the products. Actual
installation is up to the authorized local dealers. Consult with
qualified Sony personnel for installation. Use only M4 screws.
The threaded portion of the screws should protrude less than
5 mm from the rear panel.
• While the display is on, a certain amount of heat builds up
inside. This can cause burns. Avoid touching the top or rear of
the display when it is powered on or just after it has entered
standby mode.
2
Using the monitor stand
Front
10 (4)
Side
Note
When moving or installing the display when it is attached to the
stand (option), do so with at least 2 people.
3
50 (19 / )
4
10 (4)
7
25 (9 / )
8
Units: cm (inches)