Adjusting The Speaker Volume; Setting Display Mode; Automatic Screen Adjustment - Sharp LL-T15A4 Bedienungsanleitung

Adjusting the screen display and speaker volume

Adjusting the speaker volume

1. Without the OSD Menu being displayed, press the
or the button.
2. Check that [VOLUME] is selected.
If it is not selected, press the
and select [VOLUME].
VOLUME
BRIGHT
SELECT
3. Adjust by pressing the
button (increase).
Note:
- On Screen display for adjustment disappears
several seconds after the last operation.

Setting display mode

Color tone or brightness can be changed with one
command.
STD
Displays an image at the brightness level set in
"Adjusting the backlight" (p.16).
OFFICE
Displays an image at a brightness level of at least
half the maximum brightness by setting the value
of the backlight to "10". (This setting saves power.)
VIVID
Displays an image with dynamic and vivid primary
colors.
How to set
Press the / MODE button when the OSD Menu is
not displayed.
Each time the button is pressed the next menu item
appears. (STD → OFFICE → VIVID → STD)
On Screen display for adjustment disappears
several seconds after the last operation.
Note:
- If [DISPLAY MODE] is set to [VIVID], [WHITE
BALANCE] is set to [STD].
/ MODE button
button (decrease) or

Automatic screen adjustment

Options in the ADJUSTMENT Menu can be
adjusted automatically (CLOCK, PHASE, H-POS,
V-POS).
Note:
- When setting up this monitor for the first time or
after having changed an aspect of the current
system, perform an automatic screen adjustment
before use.
Automatic adjustment screen display
To perform an automatic adjustment, first display
an image that makes the entire screen very bright.
If you are using Windows, you can also use the
Adjustment Pattern on the accompanying Utility
Disk.
Displaying the Adjustment Pattern (for Windows)
This explanation is for Windows 95/98/2000/Me/XP,
and assumes that the floppy disk drive is "A drive".
Note:
- If the floppy disk drive of your computer is not
"A drive", please read the below substituting the
floppy disk drive you are using in place of
"A drive" or "A".
1. Place the Utility Disk (provided) into the
computer's A drive.
2. Open [My Computer] and select [3 ½ Floppy
(A:)]. If using Windows 3.1, open [File Manager]
and choose "A drive".
3. Double click on [Adj_uty.exe] to run the
Adjustment Program. The Adjustment Pattern will
appear.
Adjustment Pattern
After completing the adjustment, press the
computer's [Esc] key to exit the Adjustment
Program.
Note:
- If your computer's display mode is set to 65K
colors, you may see the different color levels in
each color pattern or the gray scale may look
colored. (This is due to the input signal
specification and is not a malfunction.)
17