LaserLiner AutoCross-Laser 2 XP Bedienungsanleitung Seite 14

Slope mode
3
Do not release the transportation safety device. Slide the ON/OFF switch into
the centre position and select the laser using the selection button. Sloping
planes and tilts can now be measured. In this mode, the laser lines no longer
align automatically. This is signalised by the laser lines flashing.
LASER
4
Optional: Working with the
laser receiver RX / GRX
Use an RX / GRX laser receiver (optional) to
carry out levelling at great distances or when
the laser lines are no longer visible.
XP version: To work with a laser receiver,
switch the line laser into hand receiver mode
with the Hand receiver mode button (5).
The laser lines will now pulsate with high
frequency, making the laser lines darker.
The laser receiver RX / GRX can detect
these pulsating laser lines.
XPG version: Manual receiver mode is
switched on automatically.
!
Follow the operating instructions of the corresponding laser receiver.
!
Manual receiver mode is available only for the laser lines.
14
GB
LASER LASER
Hand receiver mode
LASER LASER LASER