Sanus VLL10 Handbuch Seite 7

3
Mount the Wall Plate
Solid Concrete or Concrete Block
3-1
Mark the wall
3-2
Drill pilot holes
3-3
Insert anchors and lag bolts
[05]
6901-002034 <06>
[01]
[03]
[05]
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Mount the wall plate [01] directly onto the concrete surface.
Minimum solid concrete thickness: 20.3 cm (8 in.).
Minimum concrete block size: 20.3 x 20.3 x 40.6 cm (8 x 8 x 16 in.).
Minimum space between fasteners: 40.6 cm (16 in.).
CAUTION:
Avoid potential injuries or property damage!
Pilot holes MUST be drilled to a depth of 75 mm (3 in.) using a 10
mm (3/8 in.) diameter drill bit.
Never drill into the mortar between blocks.
75mm
(3 in.)
Insert lag bolt anchors [05]. Then insert lag bolts [04] using a drill and
the allen driver bit [03].
CAUTION:
Improper use could reduce the holding power of the
lag bolt. To avoid potential injuries or property damage:
Be sure the anchors [05] seat fl ush with the concrete surface.
Tighten the lag bolts [04] only until they are pulled fi rmly against
the wall plate [01].
DO NOT over-tighten the lag bolts [04].
[05]
[01]
[04]
10 mm
(3/8 in.)
7