Toshiba MM-U056 Installationsanleitung Seite 29

Installation of AI Room Remote Controllers
Precautions
Low-voltage circuit provision is used for remote control communication, and as such, the remote
control cable is subject to the low power circuit provision of internal wiring regulations and
!
therefore it cannot be brought into direct contact with high voltage AC power lines, or housed in
the same conduit tube as a power line.
!
All MM- models may be used with remote controller (RBC-SR2-PE);
!
This remote controller cannot be used with the 7 Day Timer (RBC-WT1-PE);
!
The use of two remotes on one system is not possible;
The maximum extended length of the remote control cable which can be used is 500 metres.
!
Install the remote controller where it can be easily operated;
The decorative cover can be removed by prising the section indicated by the arrow, using an
!
ordinary flat screwdriver;
!
The in-built memory backup capacitor will prevent memory loss during a power failure;
For details of setting the remote controller please refer to the operating instructions in the
!
Remote Controller Owner's Manual.
Flush Wall Mounting
G
Feed the 3-core PVC cable (obtained
locally) through the back of the
remote controller and then connect to
the ABC terminals.
G Attach the remote controller to the
wall using two suitable mounting
screws (obtained locally).
Wall Surface Mounting
G Attach the remote controller to the wall
using two suitable mounting screws
(obtained locally).
G Connect the 3-core cable (obtained
locally) to the ABC terminals.
G Make a U-shaped cut-out in the centre
of the top edge of the decorative cover
and pass the 3-core PVC cable
through the cut-out.
R C
EMOTE ONTROLLER
Cut-out
~ 29 ~
3-core PVC cable,
obtained locally
Mounting screws (x2)
obtained locally
3-core PVC cable,
obtained locally
Mounting screws (x2)
obtained locally
GB