Toshiba MM-U056 Installationsanleitung Seite 12

Unit Installation – MM-C, MM-CR Units continued
Hanging bolt
GB
Bolt cover
Ceiling
In case of inner hanging, adjusting height of indoor unit is
impossible after hanging – adjust it at this state
Remote Control Cord, C Units only
G Wire the cord over the refrigerant piping and the drain piping.
G If the cord was wired under the piping, it would cause difficulty in pulling out the air filter.
I
NDOOR
Hanging the Indoor Unit
INNER HANGING
Ceiling board
40mm or less*
Hanger
Hexagon bolt
M10 Plate
Side panel (right)
washer
Double nut
*Allow a jutting out length of 40mm or less
(2) Fitting State of Hanger
Wall
(3) Hanging the Indoor Unit
Slit grooves
Hexagon bolt
Fit the Hexagon bolts of the unit into slit grooves
(4) Fasten the Hexagon bolts to hang the unit
U L
NIT OCATION
(1) Fitting Hanger
Hanging bolt
Body
Ceiling
~ 12 ~
OUTER HANGING
Ceiling board
40mm or less*
Hanger
Wall
Slit grooves
Hexagon bolt