Power Supply - Seca 954 Bedienungsanleitung

– Fit the seat to the frame using the four
self-tapping plastic screws. Check that
the seat is screwed tightly to the frame
with no play at all.
– Push the hinge bolts for the armrests
through the hinge bushes on the seat
frame. Put on the washer and cap nut
(M10) and screw them tight.

Power supply

The scale is powered by a mains unit and by rechargeable batteries.
Connecting the rechargeable battery pack:
– Open the battery compartment in the
base of the display housing.
– Connect the plug contacts to the re-
chargeable battery pack.
– Close the lid of the battery compart-
ment again.
The LC display and the evaluation electronics have a low power consumption – 1,000
weighing operations can be performed with a fully charged battery.
Once battery voltage is no longer adequate, the battery symbol
the display to indicate that battery power is dropping.
If the batteries are not charged, battery voltage will ultimately not be adequate for error-
free measuring. In this case,
sible.
16
bAtt
appears in the display and weighing is no longer pos-
first appears in