Seca 954 Bedienungsanleitung Seite 19

– Read the weighing result off the digital
display.
– If a load greater than 200 kg or 440 lbs
is placed on the scale,
the display.
– To switch off the scale, press the Start
key again.
Switching the weight display
The weight display can be switched between kilogrammes (kg) and pounds (lbs) or be-
tween kilogrammes (kg) and stones (sts).
– Press the Start key with no load on the
scale. Weight is initially displayed in the
last setting selected.
– To switch the weight display between
kilogrammes and pounds, press the kg/
lbs/sts key.
– The kg or lbs display lights up.
– To switch weight display between
pounds and stones, hold down the
kg/lbs/sts key for approx. 2 seconds.
The lbs or sts display lights up.
Automatic switch-off/economy mode
The scale switches off automatically after 5 minutes.
Taring weight display (TARE)
The Tare function is very useful if an additional weight (a blanket, for example) is to be ig-
nored for weighing purposes.
Proceed as follows:
– Press the Start key with no load on the
scale.
– First place the additional weight (e.g. a
blanket) on the scale and activate the
Tare function by pressing and holding
the HOLD/TARE key.
The display is reset to zero.
in the display. The note "NET" appears.
– Now put the patient and the additional
weight on the scale.
The scales calculate the patient's
weight without the additional weight.
You can now perform as many weigh-
ing operations as you like.
Model 954
St0P
appears in
0. 0
appears
19