Automatic Switch-Off - Zanussi ZEV6642FBV Benutzerinformation

AUTOMATIC SWITCH OFF
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after you activate
the hob,
• you spill something or put something on the
control panel for more than 10 seconds (a pan,
a cloth, etc.). An acoustic signal sounds and the
hob deactivates. Remove the object or clean the
control panel.
• you do not deactivate a cooking zone or change
the heat setting. After some time
and the hob deactivates.
The relation between the heat setting and the
time after which the hob deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
THE HEAT SETTING
Touch to increase the heat setting. Touch
decrease the heat setting. Touch
same time to deactivate the cooking zone.
ACTIVATING AND DEACTIVATING THE
OUTER RINGS
You can adjust the surface you cook to the
dimension of the cookware.
Use sensor field:
To activate the outer ring: touch the sensor
field. The indicator comes on.
To deactivate the outer ring: touch the sensor
field until the indicator goes out.
AUTOMATIC HEAT UP
If you activate this function you can get a necessary
heat setting in a shorter time. The function sets the
highest heat setting for some time and then
decreases to the correct heat setting.
To activate the function the cooking
zone must be cold.
comes on
The hob deactivates
after
6 hours
5 hours
4 hours
1.5 hour
and at the
To activate the function for a cooking zone:
touch until the correct heat setting comes on.
After 3 seconds
To deactivate the function: touch
TIMER
Count Down Timer
You can use this function to set how long the
cooking zone should operate for a single cooking
session.
First set the heat setting for the cooking zone then
set the function.
To set the cooking zone: touch
again until the indicator of a necessary cooking
zone comes on.
To activate the function or change the time:
touch or
minutes). When the indicator of the cooking zone
starts to flash slowly the time counts down.
To see the remaining time: set the cooking zone
with . The indicator of the cooking zone starts to
flash quickly. The display shows the remaining time.
To deactivate the function: set the cooking zone
with and touch
back to 00. The indicator of the cooking zone goes
out.
When the time comes to an end, the
to
sound operates and 00 flashes. The
cooking zone deactivates.
To stop the sound: touch
Minute Minder
You can use this function as a Minute Minder
when the hob is activated and the cooking zones
do not operate. The heat setting display shows
To activate the function: touch
of the timer to set the time. When the time
comes to an end, the sound operates and 00
flashes.
To stop the sound: touch
To deactivate the function: touch
touch . The remaining time counts back to 00
The function has no effect on the
operation of the cooking zones.
comes on.
of the timer to set the time (00 - 99
. The remaining time counts
.
. Touch
.
.
again and
.
or
and then
9