Automatic Switch-Off - Zanussi ZEV8646XBA Benutzerinformation

Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after you
activate the hob,
• you spill something or put something on the
control panel for more than 10 seconds (a
pan, a cloth, etc.). An acoustic signal sounds
and the hob deactivates. Remove the object
or clean the control panel.
• you do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the hob deactivates.
The relation between the heat setting and
the time after which the hob deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
The heat setting
Touch to increase the heat setting. Touch
to decrease the heat setting. Touch
at the same time to deactivate the cooking
zone.
Activating and deactivating the outer
rings
You can adjust the surface you cook to the
dimension of the cookware.
Use sensor field:
To activate the outer ring: touch the sensor
field. The indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.
Automatic Heat Up
If you activate this function you can get a
necessary heat setting in a shorter time. The
function sets the highest heat setting for some
www.zanussi.com
The hob deacti-
vates after
6 hours
5 hours
4 hours
1.5 hour
and
time and then decreases to the correct heat
setting.
To activate the function the cooking
zone must be cold.
To activate the function for a cooking
zone: touch until the correct heat setting
comes on. After 3 seconds
To deactivate the function: touch
Timer
Count Down Timer
You can use this function to set how long the
cooking zone should operate for a single
cooking session.
First set the cooking zone then set the
function. You can set the heat setting before
or after you set the function.
To set the cooking zone: touch
again until the indicator of a necessary cooking
zone comes on.
To activate the function or change the
time: touch or
time (00 - 99 minutes). When the indicator of
the cooking zone starts to flash slowly the time
counts down.
To see the remaining time: set the cooking
zone with . The indicator of the cooking zone
starts to flash quickly. The display shows the
remaining time.
To deactivate the function: set the cooking
zone with and touch
counts back to 00. The indicator of the cooking
zone goes out.
When the time comes to an end, the
sound operates and 00 flashes. The
cooking zone deactivates.
To stop the sound: touch
Minute Minder
You can use this function as a Minute Minder
when the hob is activated and the cooking
zones do not operate (the heat setting display
shows ).
To activate the function: touch
or of the timer to set the time. When the
comes on.
.
again and
of the timer to set the
. The remaining time
.
. Touch
7