Zanussi ZEV6642FBV Benutzerinformation Seite 12

Problem
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
Automatic Heat Up does not
operate.
You cannot activate the outer
ring.
There is a dark area on
the multiple zone.
The sensor fields become hot.
comes on.
12
Possible cause
The fuse is blown.
You do not set the heat setting
for 10 seconds.
You touched 2 or more sensor
fields at the same time.
There is water or fat stains on
the control panel.
You put something on one or
more sensor fields.
You put something on the sen-
sor field .
The zone is not hot because it
operated only for a short time
or the sensor is damaged.
The zone is hot.
The highest heat setting is set.
You decreased the heat setting
to 0.
It is normal that there is a dark
area on the multiple zone.
The cookware is too large or
you put it too near to the con-
trols.
Child Safety Device or Lock
operates.
Remedy
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Activate the hob again and set
the heat setting in less than 10
seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
Start from 0 and increase the
heat setting.
First, activate the inner ring by
changing the heat setting.
Put large cookware on the rear
zones, if possible.
Refer to "Daily use".