Activating And Deactivating; Automatic Switch-Off - Zanussi ZEV6747FBA Benutzerinformation

ACTIVATING AND DEACTIVATING

Touch for 1 second to activate or deactivate the
hob.
AUTOMATIC SWITCH OFF
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after you activate
the hob,
• you spill something or put something on the
control panel for more than 10 seconds (a pan,
a cloth, etc.). An acoustic signal sounds and the
hob deactivates. Remove the object or clean the
control panel.
• you do not deactivate a cooking zone or change
the heat setting. After some time
and the hob deactivates.
The relation between the heat setting and the
time after which the hob deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
THE HEAT SETTING
To set or change the heat setting:
Touch the control bar at the correct heat setting or
move your finger along the control bar until you
reach the correct heat setting.
ACTIVATING AND DEACTIVATING THE
OUTER RINGS
You can adjust the surface you cook to the
dimension of the cookware.
Use sensor field:
To activate the outer ring: touch the sensor
field. The indicator comes on.
comes on
The hob deactivates
after
6 hours
5 hours
4 hours
1.5 hour
To activate more outer rings: touch the same
sensor field again. The subsequent indicator comes
on.
To deactivate the outer ring: touch the sensor
field until the indicator goes out.
When you activate the zone but do not
activate the outer ring the light that
comes out from the zone may cover
the outer ring. It does not mean that
the outer ring is activated. To see if the
ring is activated check the indicator.
AUTOMATIC HEAT UP
Activate this function to get a desired heat setting
in a shorter time. When it is on, the zone operates
on the highest setting in the beginning and then
continues to cook at the desired heating setting.
To activate the function the cooking
zone must be cold.
To activate the function for a cooking zone:
touch ( comes on). Immediately touch a
desired heat setting. After 3 seconds
To deactivate the function: change the heat
setting.
TIMER
Count Down Timer
You can use this function to set how long the
cooking zone should operate for a single cooking
session.
First set the heat setting for the cooking zone then
set the function.
To set the cooking zone: touch
again until the indicator of a necessary cooking
zone comes on.
To activate the function or change the time:
touch or of the timer to set the time (00 - 99
minutes). When the indicator of the cooking zone
starts to flash slowly the time counts down.
To see the remaining time: set the cooking zone
with . The indicator of the cooking zone starts to
flash quickly. The display shows the remaining time.
To deactivate the function: set the cooking zone
with and touch
back to 00. The indicator of the cooking zone goes
out.
comes on.
again and
. The remaining time counts
9