Cleaning And Maintenance - SOLAC CE4500 Gebrauchsanleitung

3 When the pilot light comes on, insert the steamer (9) into the liquid to be
heated and gradually open the steam nozzle control (8). Always handle
the steam nozzle (9) by the protective handle (10), to avoid potential
burns.
4 After using, we recommend you clean any traces of dirt on the inside. To
do this:
5 Place an empty container beneath it, turn on the steamer switch (8)
again and let the steam out.
6 Turn off the steam switch (3).
7 If you are going to use the steamer (9) continually to heat a large amount
of liquid (more than around 100 ml), proceed as follows: once the steam
has lost pressure (there is no force), close the steam nozzle (8) control
and turn the coffee extraction selector (2) until a little water comes out of
the coffee outlet area. Then, wait until the steam switch pilot light (3)
comes back on. Repeat these steps as often as you consider necessary.
8 If you want to make coffee after using the steam nozzle, it is advisable
to allow two cups of water to run out through the filter holder (with no
coffee in the filter) to ensure that the next cup of coffee comes out at the
right temperature.
• The maximum steam draw-off time is about 1 min.

5 CLEANING AND MAINTENANCE


Unplug the coffee maker from the mains.

Clean the tank and filter holder regularly.

Do not use alcohol, solvents or abrasive products to clean the coffee
maker or tray, just a soft damp cloth.
• If you use the steam nozzle to heat milk, clean it as soon as possible for
easy cleaning. Wait for the steam nozzle to cool down and wipe it with a
damp cloth.
• Every now and again, for more thorough cleaning of the steamer,
proceed as follows: wait until the steamer cools down and unscrew its
cylindrical part anticlockwise. Wipe the steamer spindle with a damp
cloth and soap the cylindrical part. Make sure that the small hole at the
top of the steamer is clean before refitting the part. Fit the steamer on its
spindle, screwing it clockwise.

The appliance has an automatic de-pressurising system that channels
some of the water from the dregs into the tray. It is advisable to remove
the water from the cup-holder tray regularly.
CLEANING AND MAINTENANCE
en
13